Vaisala DMT152 - Troubleshooting and Maintenance Commands

Chapter 5 ________________________________________________________ Serial Line Operation
VAISALA ________________________________________________________________________ 49
Output a Reading Once
SEND [aa]<cr>
where
aa
=
Transmitter address (0 ... 99). Must be specified if the
transmitter is in POLL mode, and a line has not been opened
using the OPEN command.
Example:
send
Tdf= -2.0 'C H2O= 5152 ppm
Troubleshooting and Maintenance Commands
Display Currently Active Errors
Use the ERRS command to display the currently active transmitter error
codes. Possible errors and their causes are listed in Table 11 on page 60.
ERRS<cr>
Example:
errs
Voltage too low error