User's Guide _______________________________________________________________________
16 ___________________________________________________________________ M210865EN-H
0710-129
Figure 4 Installing the Transmitter
4. Use a 30mm wrench to tighten the connection to 25 N m, as shown
in Figure 4. If you do not have a 30mm wrench, use a
1 3/16” wrench or an adjustable wrench.
CAUTION
Only tighten the probe from the 30mm nut. Do NOT apply force to other
points in the probe body.
5. Connect the wires of the connection cable. When using cables
provided with DMT152 see the wiring section on page 18. See the
power supply requirements on page 22.
0710-130
Figure 5 Connecting the Cable
6. Plug in the cable to the transmitter. Be sure to use the correct
connector; see section Wiring on page 18.
7. Cover the unused connector on the transmitter with the rubber plug
that is attached to the transmitter.
To Next Page
Loading...
