Chapter 13 ___________________________________________________________Recording Data
VAISALA _______________________________________________________________________ 69
CHAPTER 13
RECORDING DATA
This chapter provides instructions on data recording with the DM500.
Data Recording
You can record measurement data and view the recorded data on the
display.
1. Open MENU: press .
2. Select ►Recording/Viewing, press .
3. Select ►Record data, press .
4. Select Interval, press SET.
5. Set the measurement interval by selecting the interval time by
using the arrow buttons, press
SELECT. See the table below.
Note, you can not set longer interval than the measurement
duration !
6. Set the measurement duration (5 min, 15 min, 30 min, 1 hours, 3
hours, 12 hours, 24 hours, 7 days, 30 days, memory full) by
selecting Duration, press SET. Note the maximum recording
durations are based on the measurement interval !
7. To start recording, select
Start/Stop recording, press START. The
progress bar
is shown on the display showing the amount
of recorded data.
To Next Page
Loading...
