Transmitter Startup
When the transmitter is
powered on, it displays a
sequence of information
screens. The screens are
shown for a few seconds each.
The first screen identifies the
transmitter and the connected
measurement modules,
and shows if the transmitter
is operating normally
(status OK) or if there is an
error (status ERROR).
The second screen shows
configuration information that
is relevant to the selected
communication protocol
(BACnet or Modbus)
After the startup screens the
transmitter shows the
measurement screen. It shows
the measured parameters and
currently active indicators.
It is normal for CO
2
measurement to read 0 ppm
for a few seconds after the
startup.
To Next Page
Loading...
