Vaisala hmdw110 series - Page 34

Syntax Description
seri<cr>
Show current serial line settings.
seri [baud p d s]<cr>
Set new serial line settings for RS-485 line
(also affects the service port). The new
settings are taken into use when the device is
reset or powered up.
baud =baud rate (9600, 19200, or 38400).
p = parity
n n = none
n e = even
n o = odd
d = data bits (7 or 8).
s = stop bits (1 or 2).
Example (show current serial line settings):
seri
Baud P D S : 19200 N 8 1
Table 21 Seri Command
Keep the serial line settings at default (19200 N 8 1) for
compatibility with the RDP100 remote display panel.
Syntax Description
sdelay<cr>
Show serial line delay (response time).
sdelay [ddd]<cr>
Set serial line delay (response time).
ddd =delay, range 0 ... 255. Corresponds to
0 ... 1020 milliseconds.
Example (set serial line delay to 200 milliseconds):
sdelay 50
Serial delay : 50
Table 22 Sdelay Command
32
4 Service Port