Syntax Description
frestore<cr>
Restores the factory default settings. All
user-made settings are lost, including user
calibration. Reset the transmitter after giving
this command.
If you have replaced the
HUMICAP
®
humidity sensor of
the device yourself, you must
redo the two-point humidity
calibration using the FCRH
command after performing a
factory reset.
Example:
frestore
Factory settings restored
reset
HMD112 / 1.0.6
Table 37 Frestore Command
Syntax Description
reset<cr>
Resets the device.
Example:
reset
HMD112 / 1.0.6
Table 38 Reset Command
40
4 Service Port
To Next Page
Loading...
