Vaisala Indigo 520 User Manual (English)

Other manuals for Vaisala Indigo 520

Questions and Answers:

M
Micheal RussellAug 14, 2025
Why is login failing on Vaisala Indigo 520 Transmitter web interface?
- C
  Catherine MunozAug 15, 2025
  If you are failing to log in to the web interface of your Vaisala Transmitter, it might be due to the transmitter's time not being set correctly. Some browsers may not accept valid browser sessions if the transmitter's time differs significantly from the browser's time. To resolve this, set the transmitter's time on the touchscreen via Menu > Transmitter > Date and time. Alternatively, you can restore the factory default settings and reconnect to the web interface. Upon reconnection, you will be prompted to provide the activation code and create new users and passwords.
M
Michael BrandtAug 21, 2025
What to do after a power outage on Vaisala Transmitter?
- R
  Ryan HaynesAug 21, 2025
  If your Vaisala Transmitter experienced a power outage, simply wait for the transmitter to power up again, which should take a few minutes. Once it powers up, it will resume displaying measurements as before. To regain access to the web interface: first, check the current IP address of the transmitter on the touchscreen at the bottom left corner of the configuration menu. Then, reconnect to the web interface using this IP address.
T
Timothy MezaAug 27, 2025
How to sync Vaisala Transmitter touchscreen and web interface?
- M
  Maria MillerAug 27, 2025
  If the web interface of your Vaisala Transmitter isn't displaying the same content as the touchscreen, and you've recently made changes on the touchscreen, the web page might need a refresh. Simply refresh the web page to see the updated content.
D
Daniel HollandSep 2, 2025
Why Vaisala Transmitter showing no measurement data from probe?
- J
  Jennifer HaleSep 2, 2025
  If you are not receiving measurement data from the connected probe on your Vaisala Transmitter: * Check the status indicator on the connected probe. If it's off, ensure the probe is securely connected to the probe cable connector. * If the indicator is red, the probe sensor might be faulty and need replacement. * If the indicator is blinking green, try restarting the transmitter.

Vaisala Indigo 520 Specifications

General

Display	LCD
Humidity Range	0 to 100 %RH
Protection Class	IP65
Measurement Parameters	Temperature, Humidity
Connectivity	RS485
Storage Temperature	-40 to +80°C
Operating Humidity	0 to 100 %RH
Output	RS485 (Modbus RTU)
Housing material	Plastic
Compatibility	Compatible with Vaisala Indigo series probes