CONTENTS (Continued)
Section Heading Page
10. CONVECTION BOX INSTALLATION 28
10.1 Method 1- Front fixing to fireplace surround. 28
10.2 Method 2 - Cable retention. 28
10.3 Floor sealing. 30
10.4 Sealing convection box holes. 30
11. BURNER INSTALLATION 31
11.1 Burner and supply pipe installation. 31
11.2 Preliminary burner checks. 31
11.3 Inlet pressure check. 32
12. FITTING THE CERAMIC FUEL EFFECT 32
13. FITTING THE WINDOW 32
14. SPILLAGE AND FLAME SUPERVISION CHECKS 33
15. FITTING THE HEAT BAFFLE 35
16. FITTING THE FASCIA 35
16.1 Dream and Petrus models. 35
16.2 Petrus model. 36
17. FIREFRONT CASTING INSTALLATION 37
17.1 Fitting the Petrus rear screen assembly. 37
17.2 Fitting the Petrus fire front casting. 37
17.3 Fitting the Dream rear screen. 37
17.4 Fitting the Dream firefront casting. 37
18. FULL OPERATING CHECKS 38
19. FINAL REVIEW 39
20. SERVICING & PARTS REPLACEMENT 40
20.1 Checking the aeration setting of the burner. 41
20.2 To remove the ignition microswitch. 41
20.3 To remove the gas shut-off microswitch. 41
20.4 To remove the fascia. 42
20.5 To remove the window. 42
20.6 To remove the burner unit. 42
20.7 To replace the control slide knob. 43
20.8 To remove the thermocouple interrupter block. 43
20.9 To remove the pilot unit. 44
20.10 To remove the shut-off tap. 44
20.11 To remove the gas flow rate controller. 45
20.12 To replace the burner. 45
20.13 To remove the main burner injector. 46
20.14 To remove the appliance from the fireplace. 46
Page 6
© Baxi Heating U.K. Limited 2010.
INSTALLER GUIDE
To Next Page
Loading...
