Valor Fires 347 User Manual

5112105/03
Model 347
RADIANT / CONVECTOR GAS FIRE
Fitted with one of the following fascia
Firelite 4 Oxysafe or
Regency 4 Oxysafe
(GC No. 32-032-62)
INSTALLER: Please leave this guide with the owner
INSTALLATION AND OWNER GUIDE
We trust that this guide gives
sufficient details to enable this
appliance to be installed and
maintained satisfactorily. However, if
further information is required, our
Valor Fires Technical Helpline will
be pleased to help.
Telephone 0844 8711 565 (National
call rates apply in the United
Kingdom).
In the Republic of Ireland
Telephone 0044 844 8711 565.
© Baxi Heating U.K. Limited 2008.

Valor Fires 347 Specifications

General

Brand	Valor Fires
Model	347
Category	Indoor Fireplace
Language	English

Summary

1. SAFETY

2. LIST OF ACCESSORIES

3. APPLIANCE DATA

4. GENERAL INSTALLATION REQUIREMENTS

5. PRE-INSTALLATION PREPARATION

5.1 Unpacking.

Instructions for safely unpacking the appliance and its components.

5.2 Fireplace flue pull.

Test the fireplace flue for adequate draft before installation.

5.3 Appliance preparation.

Prepare the appliance, e.g., remove transit screws and fascia.

5.4 Fitting the battery to electronic ignition models.

Guide on installing the battery for the electronic ignition system.

5.5 Checking the ignition.

Verify manual and electronic ignition systems are functioning correctly.

5.6 Fitting the closure plate.

Instructions for fitting the closure plate to the fireplace opening for sealing.

6. APPLIANCE INSTALLATION

6.1 Installing to a hearth.

Correctly position and level the fire when installing onto a hearth.

6.2 Wall mounting.

Instructions for securely mounting the appliance to a wall.

6.3 Gas supply connection.

Steps for safely connecting the gas supply to the appliance.

6.4 Radiants installation.

Guidance on correctly installing the radiant heat elements.

6.5 Flue restrictor adjustment.

How to adjust the integral flue draught restrictor for optimal performance.

7. CONTROL AND PRESSURE CHECKS

7.1 Check control settings.

Verifying correct operation of control knob positions and ignition.

7.2 Flame supervision and spillage monitoring system.

Testing the safety system for pilot flame and flue spillage.

7.3 Check reference pressure.

Checking and verifying gas pressure settings for correct operation.

8. FASCIA FITTING

9. SPILLAGE CHECK

10. FINAL REVIEW

11. SERVICING AND PARTS REPLACEMENT

11.1 To remove the fascia.

Step-by-step guide to safely detach the appliance's fascia.

11.2 To replace radiant(s).

Instructions for removing and fitting new radiant heat elements.

11.3 To replace the pilot unit.

Guide on how to replace the pilot assembly unit.

11.4 To remove the piezo generator (Manual ignition models).

Steps to remove the piezo ignition generator on manual models.

11.5 Note for electronic ignition.

Specific considerations for servicing electronic ignition models.

11.6 To remove the complete burner module, pipes and pilot.

Procedure for removing the main burner assembly.

11.7 To grease the gas tap.

Instructions for lubricating the gas tap for smooth operation.

SAFETY

APPLIANCE DIMENSIONS

GAS CONSUMPTION

OPERATING YOUR FIRE

To light the fire (Manual ignition).

Step-by-step instructions for manually lighting the pilot and main burner.

To light the fire (Electronic ignition).

Step-by-step instructions for lighting the pilot and main burner using electronic ignition.

CLEANING YOUR FIRE

REPLACING THE RADIANTS

MAINTENANCE

Battery replacement (Electronic ignition).

How to replace the battery in the electronic ignition system.

WARRANTY AND SERVICE