11.6.4. Detach the left end of the burner module from the radiant box by removing
one screw and a wing nut (See figure 13).
11.6.5. Carefully slide the burner module to the right to free it from the right side of
the radiant box (See figure 13).
11.6.6. Remove the pipes, gas tap or injectors as required.
11.6.7. Replace in the reverse order.
Take care when replacing the injectors. The injectors have ceramic tips at each end. It
is important not to allow jointing compound to get on either end of the injectors.
Make sure that the control knob with spindle is correctly turned to agree with the gas
tap position before refitting the split pin.
11.7 To grease the gas tap.
11.7.1. Remove the burner module as section 11.6.
11.7.2. Remove the circlip holding the piezo generator to the tap and remove the
piezo generator.
11.7.3. Remove the two screws from the head of the tap and remove the gas tap
head.
11.7.4. Remove the spindle and spring from the tap.
11.7.5. Note the position of the slot in the plug. Mark this position on the tap body.
11.7.6. Rotate the plug and pull it out of the tap.
11.7.7. Clean and grease the plug lightly with suitable grease. Do not apply
excessive grease. Particularly, make sure that the gas ports are not restricted by
grease.
11.7.8. Push the plug back into the tap body. Line up the slot in the plug with the
mark previously made on the tap body.
11.6.9. Reassemble in the reverse order making sure that the components are
correctly engaged. Check the operation of the tap and piezo. Make sure that the
control knob with spindle is correctly turned to agree with the gas tap position before
refitting the split pin.
INSTALLER GUIDE
© Baxi Heating U.K. Limited 2008.
Page 26
To Next Page
Loading...
