13. BURNER AND SUPPLY PIPE INSTALLATION 27
13.1 Burner installation. 27
13.2 Supply pipe installation. 27
13.3 Burner checks. 27
13.3.1 Lighting the fire. 27
13.3.2 Adjusting flame height. 28
13.3.3 Adjusting to pilot only setting. 28
13.3.4 Turning off. 28
13.4 Check inlet pressure. 29
14. FITTING THE CERAMIC FUEL EFFECT 29
14.1 Fitting the rear ceramic wall. 29
14.2 Fitting the side ceramic walls. 29
14.3 Fitting the ceramic support. 29
14.4 Fitting the port cover. 29
14.5 Fitting the ceramic fuel effect. 30
15. FULL OPERATING CHECKS 32
15.1 Check the burner operation. 32
15.2 Check for spillage. 32
15.3 Flame supervision and spillage monitoring system. 32
16. FASCIA INSTALLATION 33
17. FINAL REVIEW 34
18. SERVICING & PARTS REPLACEMENT 35
18.1 Checking the aeration setting of the burner. 36
18.2 To remove the window panel. 36
18.3 To remove the fuel effect. 36
18.4 To remove the ceramic side walls. 37
18.5 To remove the burner unit. 37
18.6 To remove the pilot unit. 37
18.7 To remove the gas valve. 38
18.8 To remove the receiver box. 39
18.9 To remove the thermocouple interrupter block. 39
18.10 To replace the burner. 39
18.11 To remove the burner injector. 40
18.12 To remove the appliance from the fireplace. 40
© GDC Group Ltd. 2013
Page 6
CONTENTS (Continued)
Section Page
INSTALLER GUIDE
To Next Page
Loading...
