Valtra VALMET Series User Manual

24
Model Code Page
21. Engine
1. 9. 1992
6000--8750 210 2
15. 6. 1992
D . Connecting rods, weight classes 4.................................................
E. Changing piston rings 5..........................................................
F. C h e ck i n g p i s t on 6...............................................................
G. Fitting piston pin 6..............................................................
H. Fitting piston together with connecting rod 6........................................
3. Balancer unit, 420---engines:
A. Removing and dismantling balancer unit 7..........................................
B. Reconditioning balancer unit 7....................................................
C. Fitti ng balancer unit 8............................................................
Engine timing gears (Op. no. 214)
A. Removing timing gear casing 1...................................................
B. Reconditioning idler gear 1.......................................................
C. Fitt ing timing gear casing 2.......................................................
Lubrication system and oil sump ( Op. no. 215) :
A. Reconditioning oil relief valve for lubrication oil pressure 1.............................
B. Removing and dismantling lubricating oil pump 1....................................
C. Assembling and fitting lubricating oil pump 2.......................................
D . Fitting oil sump gasket 2.........................................................
E. Lubricating oil quality requirements 3..............................................
Inlet a nd exhaust system, turbocharger (Op. no. 216):
A. Checking air filter 1..............................................................
B. C hecking inlet and exhaust system 1...............................................
C. Checking turbocharger 1.........................................................
D. Reconditioning turbocharger 3....................................................
E. Fitting turbocharger 5............................................................
Working orders (Op. no. 219) 1................................................
https://www.truck-manuals.net/

Valtra VALMET Series Specifications

General

Engine	Agco Power
Fuel Type	Diesel
Drive	4WD
Engine Power	75-400 HP
Hydraulic System	Open or Load-sensing
PTO	540/1000 rpm
Weight	Varies by model
Fuel Tank Capacity	Varies by model