VAMP 130 Overcurrent and earth-fault relay
Operation and Configuration
VAMP Ltd
22
Vamp 24h support phone : +358 (0)40 573 6316 VM130.EN003
6. PC software
6.1. PC user interface
The PC interface is intended to be used for onsite
parameterization of the relay and for reading of measured
values to a computer or loading of the relay software from a
computer.
The RS 232 serial port is available for the connection of a local
PC on the front panel of the relay. To connect a PC to the serial
port use a connection cable of type VX 003-3.
6.1.1. Using the VAMPSET program
See separate user’s manual for the VAMPSET software,
VMV.EN0xx. If the VAMPSET software is not available please
download it from www.vamp.fi.
To Next Page
Loading...
