Vanderbilt ACT 5e - Restore Factory Defaults

Step Keypad Entry Operation
2 0or1 0=Backlightalwaysoff,1=Backlightalwayson
3 41 Setautobacklight.
4 0or1
0=Autobacklightoff,1=Backlightonifpressed.
Permanentbacklightsettingoverridesautobacklightsetting.
3.5 Restore factory defaults
Entertheprogrammingcodefollowedby .ThisrestorestheACT5etoitsdefaultsettings.
Iftheprogrammingcodehasbeenforgotten,setitto9999asfollows:
1. Removethepowerfromtheunit.
2. RemovelinkLK1atthebackoftheunit.
3. Applypowertounit.
4. Wait3secondsandremovethepoweragain.
5. ReplacelinkLK1.
6. Restorepower.
Theprogrammingcodeisnowsetto9999.Proceedwithprogramming.
 ThekeypadwillnotoperatecorrectlywithoutLK1inplace.
ACT 5e Digital Keypad – Installation Manual ACT 5e Digital Keypad Programming
© Vanderbilt 2018 7
A-100443
31.01.2018