5 Mounting and connecting
The Mullion readers are surface-mounted readers. The units can be mounted with cables led through the
back of the unit or led in from either side through knockout gaps.
For wiring details please refer to:
l Connecting the cables on page13.
5.1 Mounting a reader
The surface should be flat to ensure a close fit.
To attach the base to the wall:
1. Make a small hole in the base gasket. Use this hole to feed the cable through the gasket and into the
reader base.
2. Attach the base to the wall with three screws: one in the middle at the top of the base, and one in
each of the corners at the bottom of the base.
1 Tamper base
2 Tamper screw
3. If tamper protection is required, fix the screw into the hole on the tamper base. Do not over tighten
the screw as this can damage the tamper base.
4. Continue to follow the instructions detailed in Connecting the cables on page13.
© Vanderbilt 2018 10
A-100410
21.06.2018
To Next Page
Loading...
