8 Default settings
Reading MIFARE Classic UID
Reading MIFARE Plus SL1 – SL3 UID
Reading MIFARE DESFire EV1 UID
Communications mode
OSDP (to change to Wiegand mode
remove Jumper 1 and Jumper 3)
Backlight Always on (change with 3CT tool)
Bus address 1 (Up to eight are supported)
Wiegand output 32 bit
Wiegand key PIN burst 8 bits
Light frame
Follows Red, Green LED inputs in
Wiegand mode
Tamper/Yellow Connection
Tamper output (change to yellow LED
with 3CT tool)
Wiegand heart beat mode OFF
Time-out for configuration card
(keypad backlight turns off when this
timeout expires subsequent to last
keypress)
3 seconds
Activation time-out 30 seconds
Hold-off time for card read 100 milliseconds
Reception for card (time before the
same card will be detected in the field
again)
Inactive
Min background illumination 12
Max background illumination 255
Off-line indication Yes
Buzzer volume for key press 2
Buzzer volume for card read 2
System sound 10
© Vanderbilt 2018 20
A-100410
21.06.2018
To Next Page
Loading...
Need help?
General
