1 A,B,0V
2 +12/24V
1. Connect the cables as shown in the table on the previous page.
2. Use this terminal to supply power to the readers.
10.2 Setting the OSDP address for the card reader
The ACTpro 1520e controller automatically assigns an address to each reader. Therefore,
jumper 2 should be removed for OSDP operation. The serial number of the reader is used to
identify and enrol a reader on the system . This can be found on a sticker on the reverse of
the front cover of the reader (bordered in red in the image below).
Mullion Reader – User Manual Connecting the card reader to ACT
© Vanderbilt 2018 26
A-100410
21.06.2018
To Next Page
Loading...
