8.2 Setting burst mode using the keypad
The default burst mode is 8 bit. This can only be changed to 4 bit if you are using the card reader in Wiegand mode.
* This indicates the bottom of the reader
To change from 8 bit to 4 bit burst :
1. Ensure Jumper 1 and Jumper 3 are removed .
2. Power up the reader while holding the X key. The red and green indicators alternately turn on.
3. Press the key sequence 1414 to specify that 4 bit burst is required.
4. Hold down the ✓ key until you hear the affirmative beep.
5. To change back to 8 bit burst from 4 bit burst, follow the steps above pressing the key sequence
1818 instead of 1414.
© Vanderbilt 2018 22
A-100410
21.06.2018
Mullion Reader – User Manual Default settings
To Next Page
Loading...
