1 Tamper base
2 Tamper screw
6. If tamper protection is required, fix the screw into the hole on the tamper base. Do not over
tighten the screw as this can damage the tamper base.
7. Feed the cables through the opening and reinsert the gasket. Proceed to the instructions for
Connecting the cables on the next page.
Vanderbilt recommends sealing the gap that the knock out creates with a sillicone
sealant. Do this after you have closed the reader. Please note that a reader with a
removed knock out is not IP 55.
© Vanderbilt 2018 12
A-100410
21.06.2018
Mullion Reader – User Manual Mounting and connecting
To Next Page
Loading...
