Vanderbilt VR50M-MF - 10.3 Connecting the card reader to ACT in Wiegand mode

During install:
1. Record the 7 digit serial number.
2. Record the door name.
3. Record if a reader is an entry or exit reader.
In the OSDP reader section of ACTEnterprise Software, configure:
1. Name
2. Serial number
3. Direction
10.3 Connecting the card reader to ACT in Wiegand mode
For more detail on connecting the card reader to ACT via Wiegand see section 5.3.3 in Connecting the cables on
page13 Please note that if you are connecting an exit reader in Wiegand mode, you should wire the D0 from the
reader to SENSE on the ACTpro 1520e (bordered in red on the image on the next page).
© Vanderbilt 2018 27
A-100410
21.06.2018
Mullion Reader – User Manual Connecting the card reader to ACT