8.1 3CT Tool
To change the default configuration of the reader, use the 3CT tool. You can purchase the 3CT tool as a
separate download. You can use the 3CT tool to configure MF Classic and DESFire EV1 card formats to
be configured along with Wiegand options to be used for the card readers. For further information, please
contact the supplier of this reader. The 3CT tool configures the format in which user cards are interpreted
by the card reader. The 3CT tool supports configuration of the following options:Tamper Output / Yellow
Input and Heart beat Mode.
Option Default setting Information
Yellow input Disabled
Selects Tamper Output
when disabled
Heart beat mode Disabled
Ensures a comms
message is sent every 10
seconds to controller when
enabled
For more information on 3CT please see the User manual for Configuration Card Creation Tool which
is included when you purchase the 3CT tool.
The readers use FreeRTOS. For further information, please visit www.freertos.org.
Mullion Reader – User Manual Default settings
© Vanderbilt 2018 21
A-100410
21.06.2018
To Next Page
Loading...
