ProStar 430 Autosampler Control Manual - 26 - 03-914947-33:2
Dispense to Sample, Waste, Destination, Reagent A…D or
Wash a programmed volume (Amount) from the buffer tubing.
In this case, it is not possible to dispense a larger volume than
the volume aspirated in previous actions. Speed and Height
can be programmed.
NOTE: Refer to the Appendix to find the Syringe Speed values depending on the type of
syringe.
Wait to program a pause (from 0 to 599.99 minutes). During the
pause, the needle will move to home position (if the previous
step is an Aspirate from or a Dispense to action). To keep the
needle in the same position, an Aspirate from or a Dispense to
step of 0 µL must be programmed at the desired position.
Repeat the X entered last Step(s). The Count parameter
defines how many times the Step(s) must be repeated.
Rinse+Wash a programmed needle volume (Amount). Buffer is
rinse to waste.
Injector valve programs the positions (Inject or Load) of the
high pressure injection valve.
Syringe valve controls the connections of the syringe to one of
its three tubes (Needle: connection to sample needle, Wash:
connection to wash solvent bottle and Waste: connection to
syringe waste tubing).
Solvent valve programs the positions (from 1 to 6) of the high
pressure Solvent Selection Valve.
Stream valve programs the positions (1-6 or 1-2) of the high
pressure ISS valve.
To Next Page
Loading...
