Page 29
3.1.6 Value buttons (+ and -)
The value buttons appear as 2 squares with a + and - sign on
them. They are used to increase or decrease the value on the
LED window. Press the button once and release it to increase
or decrease the value by one increment. The value may be
changed quickly by keeping your finger on either button.
3.1.7 Output segments
On the right-hand side of the faceplate appear 11 LEDs
vertically aligned, next to which is a list of 11 outputs (1 alarm
and 10 multi-purpose outputs). A LED comes on whenever the
respective output is active or in alarm.
3.2 SETTINGS
The User’s Guide contains a description of only a few settings
that appear in most configurations, such as: ramping, growth
day, alarm. The other settings, which are easier to set, are
briefly explained in the configuration document.
3.2.1 Time of Day (time clock)
The IC-610 comes with its own integrated time clock. This
feature is appreciated by users who want to know the current
time of day. Note that if a power failure occurs, the clock will
keep the time at which the failure occured. However, the time
clock’s main purpose is to allow ramping and feed & water
consumption monitoring, as these events occur every 24 hours
or at midnight each day.
The following instructions show how to change the time of day
on the control:
F1:
The time is displayed in a HH:MM format and does
not flash. The + and - buttons serve no purposes.
F2:
Minutes are flashing and can be adjusted with the
+ and - buttons.
F3:
Hour is flashing and can be adjusted with the +
and - buttons.
To Next Page
