Page 5
CHAPTER 1 - INTRODUCTION
1. GENERAL
This document provides you with the necessary
information to install and operate the IC-610 as well as the
IC-610SL (see page 6) . The information is presented as
follows:
•
Introduction
• Installation
• User’s Guide
•
Appendix
1.1 DESCRIPTION
Congratulations on your purchase of the IC-610 ventilation
system. You have just acquired one of the safest, most
reliable and userfriendly controls on the market. The IC-
610 provides you with full control over temperature,
humidity, pressure and heat, resulting in a comfortable
environment for your livestock.
The IC-610’s features are:
• Possibility to connect 6 sensors of the following types:
static pressure, relative humidity, potentiometer, in-out
temperature, (4-20 mA), and feed & water.
• 6 ON/OFF relays
• without PM-1 - 8 var. stages (4 VSM-2) and 6 ON/OFF
stages
with PM-1 - 4 var. stages (4 fans max each) and 6 ON/
OFF stages
or 6 ON/OFF stages and 8 ON/OFF stages (CM3-2 or
CM10-2)
• Ramping (minimum speed, temperature, humidity, etc)
• High and low temperature recall
•
Control & monitoring of feed and water consumption
•
Alarm logic: high-low temp., power/control/probe
failure, feed & water, fan failure
• Internal alarm relay with a 8 second time delay
•
Second fan compensation (prevents drastic increases
of CFM)
• Cool cell operation and air inlet control
•
Fan speed display (RPM) with Smart Fans only
CHAPTER 1 - INTRODUCTION
To Next Page
