VAT 61532-KEAQ-0001 - Page 89

Installation, Operating & Maintenance Instructions
Series 615 DN 40 (I.D. 1½”), DeviceNet
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
603476EA
2013-07-25
89/102
Description
Required tool
29. Slide both o-rings onto shaft till the end
30. Deposit 0.05 ml vacuum grease between
the o-rings
31. Clean shaft from vacuum grease
Vacuum grease
Cleanroom wipes
Mount mechanical unit to valve body
32. Install mechanical unit into valve body, see
picture
33. Fasten and tighten the 2 mounting screws
with 2.5 Nm
Allen torque wrench
3mm
Assemble and adjust
plate
34. Place the plate on the shaft in the valve
body