VAT 64 Series - User Manual

Installation, Operating & Maintenance Instructions
Series 64, DN 63-400 (I.D. 2
1
/2" - 16")
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
219034EM
2013-08-27
1/19
Control Gate Valve
with 3-position pneumatic actuator
Sample picture
This manual is valid for the valve ordering number(s):
640.. - .E.8 - . . . .
The fabrication number is indicated on each product as per the label
below (or similar):
made in Switzerland
Fabrication No.:
patented
. .
640 . . – . . . . – . . . . / . . . .
A – . . . . . .
Fabrication number
Explanation of symbols:
Read declaration carefully before you start any other
action!
Keep body parts and objects away from the valve
opening!
Attention!
Hot surfaces; do not touch!
Product is in conformity with EC guidelines,
if applicable!
Loaded springs and/or air cushions are potential
hazards!
Disconnect electrical power and compressed air lines.
Do not touch parts under voltage!
Wear gloves!
Read these «Installation, Operating & Maintenance Instructions» and the enclosed «General
Safety Instructions» carefully before you start any other action!
FOR SALES AND SERVICE PLEASE CALL:
PTB SALES
T :: 626.334.0500
sales@ptbsales.com
service@ptbsales.com
www.ptbsales.com
DATE SERVICED:
VIEW OUR INVENTORY

VAT 64 Series Specifications

General

Brand	VAT
Model	64 Series
Category	Control Unit
Language	English