Vaya BUDDY-2 - INSPECTION, MAINTENANCE, AND STORAGE; SAFETY TIPS FOR CHARGING; CHARGER SPECIFICATIONS; INSPECTING YOUR E-BIKE

20
ELCARE NORDIC: service.vaya@elcare.com
Step 6: Flick the power switch on the charger to the on position.
Step 7: The charger indicator light should now turn to red to show that the bike is
charging. The bike is fully charged when the charger indicator light turns green. The
charger automatically stops charging when the charging light turns green.
Step 8: Flick the power switch on the charger to the off position. Disconnect the charger
from the mains power. Disconnect the charger from the bike.
Note: If the charging indicator light does not turn red when the bike is connected for
charging, then check that all plugs are properly connected, and the charger power switch
is turned to the on position, or check if the battery is already fully charged.
Note: The battery can also be removed from the bike for charging. Follow the same steps
as above.
Safety tips for charging
Charge the battery fully before using it for the rst time.
To extend the battery life, charge the battery at least every 2 months, and not more than
two days after usage. Charge it within the correct temperature range.
Do not charge the battery longer than necessary. Turn off the charger when the battery is
fully charged.
Do not store the battery without charging it. Charge the battery at least every 2 months.
Only use the supplied charger to charge the battery.
Do not use the charger if the charger or the charger cable is damaged. Contact support
for a replacement.
Charger specications
Standard charger 48 V
Model number: DPLC110V55Y
Input: 110 – 240 V, 2A, 50/60 Hz
Output: 54.6.0V
2.0 A
INSPECTION, MAINTENANCE, AND STORAGE
Your e-bike requires routine inspection and maintenance. This chapter describes
maintenance steps and important operating tips. Before you perform the following
operations, ensure the power and charging cable is disconnected.
The bicycle (e.g. non-electrical) parts of the e-bike are standard components that can
be obtained from your local bike shop. Ensure that replacement parts are genuine parts.
Contact customer support if in doubt.
Use of non-genuine or non-compatible parts, or modication of the bicycle outside its
specications is considered tampering. Tampering may result in increased risks to the
user and the user bears responsibility for any resulting issues.
Inspecting your e-bike
Routinely check the frame and tyres of the e-bike for damage or excessive wear and for
correct tyre pressure, check all bolts and screws and tighten them if needed.
Check that the handlebar screws are secure. Check that the handlebar cannot be moved
up and down.
Check the side of the front and rear wheels for correct tyre pressure. See markings on
tyres for correct tyre pressure.
The rims are subject to wear, which must be checked to ensure safety.
Check the brake pads for wear. If they are worn (approx. 1 mm left), replace the brake
pads immediately.
See service folder for more information.