ELCARE NORDIC: service.vaya@elcare.com
Fine-tune the brake cable tension
To tighten the cable tension, turn counter clockwise.
To reduce the cable tension, turn clockwise.
Noise from brakes
- The brake disc needs cleaning.
- You need to clean or sand the brake pads to remove impurities.
- The brake pads are worn and must be replaced.
The brakes are not working
- Brake cable is need of adjustment. Adjust length of brake cable.
- Brake pads are in need of adjustment. Adjust the position of brake pads.
- The brake pads are worn and must be replaced.
Inspecting the trueness of the wheels
Over the lifetime of the bike, the wheels may begin to run out of true.
To check the trueness of a wheel, lift the e-bike and spin the wheel. If the wheel wobbles
from side to side, then the wheel is out of true and will need repairing.
Special tools are required for repair. We recommend that the wheels be trued by a qualied
repair technician. Contact your local retailer for more information on wheel repairs.
Inspecting the wheel bearings
Over the lifetime of the bike, the wheel bearings may become worn and will need servicing.
To check, grab the tyre of either the front or rear wheel while holding the bike securely.
Vigorously move the tyre from side to side. If the wheel moves at the wheel hub (the
centre of the wheel), the bearing may be worn.
Special tools are required for repair. We recommend that the bearings be replaced by a
qualied repair technician. Contact your local retailer for more information on wheel repairs.
24
To Next Page
Loading...
