23
ELCARE NORDIC: service.vaya@elcare.com
Step 3:
When lifting the rear of the bike and turning the pedals by hand, use the gear change to
change the highest to the lowest gear one at a time. If the derailleur is adjusted correctly,
the gears should shift quickly without any grinding noise.
If there are still problems after you adjust the rear derailleur, you can ne-tune it.
Rotate the adjuster (C) clockwise if there is a problem when going from the lowest gear
to the highest gear.
Rotate the adjuster (C) counter-clockwise if there is a problem when going from the
highest gear to the lowest gear.
Turn the adjuster about a quarter turn at a time and then change the gears to see if the
problem is xed. Repeat step 3 if the problem persists.
Mechanical brakes
The brake pads are worn over time. Adjustments are needed as the brake pads are
wearing down.
If the brakes are too tight or too loose, then loosen the bolt that holds the brake cable
in position.
To tighten the cable tension: Decrease the length of the brake cable.
To loosen the cable tension: Increase the length of the brake cable.
To Next Page
Loading...
