10
VEGAPULS 6X
66216-EN-220518
•
No loose connections of the line connections, equipotential bonding connections
•
Correct and clearly marked cable connections
The parts of the VEGAPULS 6X being in contact with ammable media during operation must be
included in the periodic overpressure test of the plant.
1
1 Red threaded or dust protection cap
3
2
1
1 Label: Type and size of the thread ½-14 NPT or M20 x 1.5
2 Label: Type and size of the thread ½-14 NPT or M20 x 1.5
3 Screw plug
6 Operation
•
Do not operate the device outside the electrical and thermal specications given in this safety
instruction
•
Modications on the instrument can inuence the explosion protection and hence the safety
•
Modications must only be carried out by employees authorized by VEGA
•
Note the relation between process temperature on the sensor/antenna and the permissible
ambient temperature on the electronics housing. For permissible temperatures, see the respec-
tive temperature tables. See chapter " Thermal data".
•
The information on mechanical wear in the operating instructions must be observed
•
The continuous operating temperature of the connection cable must be suitable for the tempera-
ture range of the application
•
Only original spare parts or spare parts approved for the purpose may be used for repairs
To Next Page
Loading...
Need help?
General
