杭州威狐智能科技有限公司
Hangzhou VeloFox Intelligent Technology Co,. Ltd.
文件编号
版本号
1.01
第19 页/共 31页
6.6 Walk assist function
When speed is 0, long press button to enter walk assist mode, motor outputs power according
to the set speed and control the actual walk speed, display shows the walk assist icon and the real-
time speed. Release button or any other button to exit walk assist mode, the motor is turned off,
and the display gets back to the basic interface. Walk assist interface, shown as below：
6.7 Battery power indicator and assist power output
Battery power information is divided into battery bar indication and remaining percentage
indication. When battery power is normal, battery capacity is divided into 5 bars. Before
communication is established, the battery percentage is not displayed, and the power bar is full and
blinks at 2Hz. After battery info is acquired, power bar will stop blinking, and displays the power
percentage. If communication is not successful within 3s, it will stop blinking and no power percentage
will be displayed.
After battery capacity is lower than 5% or the voltage is lower than low voltage value, display
will enter the low-voltage mode. In this mode battery level showed level 0 and border blink at 1Hz,
with no power output from the motor, and disabled assist level switch. Power assist level is displayed
as OFF or 0.
To get out of low-voltage mode, reset, and increase the voltage above low-voltage value and
battery capacity above 5%.
Percentage of battery power and power level table（Battery % info is required from BMS or
controller）：
To Next Page
Loading...
Need help?
General
