杭州威狐智能科技有限公司
Hangzhou VeloFox Intelligent Technology Co,. Ltd.
文件编号
版本号
1.01
第10 页/共 31页
① All RM series buttons are compatible with DM02 series displays, the power-on button is located
on the top side of the display.
② Standard Outlet is a board end connector, which is convenient for after-sales maintenance and
replacement.
③ 3.5 inch HD high brightness IPS LCD screen meets the need for customization of the boot
interface and UI interface
4.3 Function interface introduction
Boot interface and basic function interface
Boot logo interface is displayed for 3 seconds after display is turned on. When the
communication connection is established, display enters the main interface, showing real-time
information stored in the controller and battery BMS according to the communication protocol.
(Battery indicator will not show battery percentage if BMS info is not available)
The basic function interface contains real-time speed, power information, power gear, clock
information, light indicator, connection status and cycling statistics display.
Mileage statistics show speed and mileage information，including average speed, maximum
speed, and TRIP info which is subtotal mileages as shown on basic interface. Speed display value has
3 digits, maximum value is 99.9KM/H, including one digit after the decimal point. Subtotal mileage
Boot logo interface
customization available
upon request
Boot Interface
Basic Interface
Speed info
Battery indicator
RTC Real-Time clock
Power output by motor
Bluetooth connection
indicator
Headli
ht indicato
volta
e indication
助力档位
辅助显示
Subtotal mileage
To Next Page
Loading...
Need help?
General
