Vemer Iride - Page 43

- 41 -
Iride Chronothermostat User Manual
Timed off
If in off status you set a timing, such off status will be maintained until the end of
the timing, operation will then switched to the one active before the deactivation
(automatic or manual).
If you set a timing, the display shows the symbol .
Attention: the timing is calculated in minutes and for this reason if for
example you set a timing of 3 days at 12:15 on Tuesday it will expire at 12:15
on Friday.
Attention: the timings can end before their programmed expiration if one of these
actions occur:
- time/ date modification (modification of the summer time change included)
- manual modification of the operating mode
- switching of digital input (only for battery models)
- change of the operating logic from winter to summer (or viceversa)
To set a timing, see chapter “Timing setting” at page 26.
English