TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON(S)
OBSERVE THE FOLLOWING:
1. These units are intented for residential installation only.
2. Use these units only in the manner intended by the manufacturer. If you have questions,
contact the manufacturer at the address or telephone number listed in the warranty.
3. Before servicing or cleaning the units, disconnect power cord from electrical outlet.
4. Installation must be done in accordance with all applicable codes and standards, including
fire-rated construction codes and standards.
5. These units are not designed to provide combustion and/or dilution air for fuel-burning
appliances.
6. When cutting or drilling into wall or ceiling, do not damage electrical wir ing and other
hidden utilities.
7. Do not use these units with any solid-state speed control devices other than the Breeze
main control for the PRO250 unit exclusively or the 11136 main control for PRO225 unit.
The optional auxiliary control 20-minute lighted push button can be used with both
PRO250 and PRO225 units.
8. These units must be grounded. The power supply cord has a 3-prong grounding plug for
your personal safety. It must be plugged into a mating 3-prong grounding receptacle,
grounded in accordance with the national electrical code and local codes and
ordinances. Do not remove the ground prong. Do not use an extension cord.
9. Do not install in a cooking area or connect directly to any appliances.
10. Do not use to exhaust hazardous or explosive materials and vapors.
11. Do not run any air ducts directly above or closer than 2 ft (0.61 m) to any furnace or
its supply plenum, boiler, or other heat producing appliance.
12. When performing installation, servicing or cleaning of these units, it is recommended to
wear safety glasses and gloves.
13. When applicable local regulations comprises more restrictive installation and/or
certification requirements, the aforementioned requirements prevail on those of this
document and the installer agrees to conform to these at his own expenses.
CAUTION
1. To avoid premature clogged filters, turn OFF the unit during construction or renovation.
2. Please read specification label on product for further information and requirements.
3. Be sure to duct air outside – Do not intake or exhaust air into spaces within walls or
ceiling or into attics, crawl spaces, or garage.
4. Intended for residential installation only in accordance with the requirements of NFPA 90B.
5. The ductwork is intended to be installed in compliance with all applicable codes.
6. Do not use the PRO250 or PRO225 unit when varnishing. The varnish vapors may
damage these units.
7. At least once in a year, the unit mechanical and electronic parts should be inspected
by qualified service personnel.
8. During snow/rain storm, operate the PRO250 unit in recirculation mode to prevent water
build up in the heat recovery ventilator. Tur n OFF the PRO225 unit.
WARNING
To Next Page
Loading...
