Network Camera User’s Guide
11/83
Hardware Installation
1. Fix IR camera to desired location with wall mount fixture
2. Plug-in Network Cable into Ethernet port
Connect an Ethernet cable to the LAN socket located on the Network Camera’s back
panel and attach it to the network.
3. Connect RS485 two wires to RS485 D+ and D- ( if you need to control PT
scanner)
4. Plug-in Power cable into power socket
5. Connect Video BNC connector to a local TV (for checking camera viewing
angle)
6. Done
Once you have installed the Network Camera well, the status LED will turn on. It means
the system is booting up successfully. Furthermore, if you have a proper network
connection, and access to the Network Camera, the 10/100M LAN LED will flash
To Next Page
Loading...
Need help?
General