4
Important Safety Instructions
Read this manual thoroughly before first use and keep it in a safe place for future
reference, along with any warranty information, your purchase receipt and the carton.
The safety precautions enclosed in this manual reduce the risk of fire, electric shock
and injury when correctly adhered to. Follow all instructions and take notice of all
warnings.
IMPORTANT WARNINGS AND CAUTIONS!
Electrical Safety and Cord Handling
• Voltage: Before installing this TV set, make sure your outlet voltage corresponds
to the voltage stated on the TV’s rating label.
• Protect from moisture: To reduce the risk of fire or electric shock, do not expose
this TV to rain or moisture; do not use it anywhere near water; do not touch the
power plug with wet hands.
• Damage: Do not use a damaged power cord, plug or loose outlet. Doing so may
cause an electric shock.
• Power outlet: Do not plug several devices into the same outlet. Doing so may
cause the outlet to overheat and start a fire. Make sure the outlet is properly
earthed and readily accessible during operation of the equipment.
• Power plug: Make sure the plug is properly installed before inserting it fully into
the outlet. A loose or improperly inserted power plug may cause a fire. The mains
plug is used as the power disconnect device and shall remain readily accessible
and operable.
• Protect the cord: Do not bend, twist or kink the power cord excessively. Do not
allow anything to rest on or roll over the power cord and antenna cable. Doing
so may cause a fire or an electric shock. Do not run the power cord near heat-
producing appliances such as radiators, stoves or irons. The excessive heat could
melt the insulation and expose live wires, resulting in fire or electric shock.
• Disconnect: Always grasp the plug when disconnecting the power cord. Pulling
the cord can damage the internal wire and may cause a fire.
• Lightning storms: Unplug this TV during lightning storms or when unused for
long periods of time. Not doing so may result in fire or electric shock.
The lightning flash with an arrowhead
symbol within an equilateral triangle is
intended to alert you to the presence
of non-insulated dangerous voltage
within the product’s enclosure that
may be of sufficient magnitude to
constitute a risk of electric shock to
persons.
The exclamation point within an
equilateral triangle is intended
to alert you to the presence of
important operating and maintenance
(servicing) instructions in the literature
accompanying the product.
To reduce the risk of electric shock, do not remove
the cover (or back).
This unit contains no user-serviceable parts inside.
Refer all servicing to qualified service personnel only.
To Next Page
Loading...
