12
1.2.1 -INHIBIT TIME PROGRAMMING
Press 1 2 1 from the main menu.
This function is used to inhibit all time
programming for a specific date and time.
(However, the clock strike programming will
continue to run).
The program will be erased from the memory
immediately after it has been executed,
Enter the time (hours and minutes) at which to inhibit
the bell events from playing and confirm by pressing OK.
If necessary, using the arrows, position the cursor on the
date to be modified and press OK to confirm.
The display will show:
Change the hour and minutes to set the enabling time
and confirm by pressing OK.
If necessary, using the arrows, position the cursor on the
date to be modified and press OK to confirm.
These two steps are required, as the first step inhibits the time programming
and the second step enables it again. Wrong settings could cause the machine
to function unexpectedly.
When programming is inhibited the hourglass icon will turn off on the main display.
To Next Page
Loading...
Need help?
General