Forecourt Controller Interface Installation Guide 3
August 11, 2016
General Requirements
Before you start, read the following important information:
1. Changes or modifications not expressly approved by Verifone, Inc., could
void the user’s authority to operate this equipment.
2. This equipment is not intended to be repaired by the user. All repairs
must be performed by an Authorized Service Technician or a Verifone
VAS C.
3. All installations must comply with the requirements of the National
Electrical Code (NFPA 70), the Code for Fuel Dispensing Facilities and
Repair Garages (NFPA 30 and 30A), OSHA regulations, including Standard
29 CFR 1910.147, and all other applicable national and local codes.
Table 1: Forecourt Controller Interface Box (P/N M149-901-01-R)
Quantity Item Verifone Part Number
(1) unit Forecourt Controller Interface
Box
Includes:
- Locking ribbon cables (4)
- AC Power Cable
- Current Loop Board
M149-901-01-R
(1) per unit Forecourt Controller Interface
Installation Guide
DOC149-901-01-R,
Revision C00
Table 2: Materials Provided by Installer
Quantity Item
Various lengths 18 AWG plenum rated twisted-pair cable (for example,
Belden P/N 88760). Lengths depend on configuration.
(20) per unit Wire nuts for splicing 18 AWG wires
(3) per unit 1-inch metallic conduit fittings
(1) per unit 1/2-inch Romex cable clamp
(4) per unit #8, 1-1/2 inch wood screws
(4) per unit 1/8 inch toggle bolts. 3 inches long