VeriFone Forecourt Controller Interface User Manual

20 Forecourt Controller Interface Installation Guide
August 11, 2016
Mounting the Unit
Before you mount the unit, remove one or more of the 1-inch knockouts into
which to install 1-inch conduit fittings for routing the dispenser control wires.
The number of knockouts to be removed will depend on how many dispenser
control wires there are. It will be easier to do this now than after the units are
mounted.
Install 1-inch metallic conduit fittings into the knockout holes where the
dispenser control wires will enter the enclosure. More than one fitting may be
needed, depending on the number of dispenser control wires.
Mount the FCI unit in the orientation shown in to the following illustration. This
provides convenient access to the dispenser control cables, which, at most
sites, come up through a conduit in the floor.
Knockout Locations

VeriFone Forecourt Controller Interface Specifications

General

Brand	VeriFone
Model	Forecourt Controller Interface
Category	Recording Equipment
Language	English