Secure PumpPAY Retrofit Kit Configuration Guide
November 10, 2011 31
2. Press [ENTER].
3. The default IP for the media proxy is 192.168.31.1. You should not have to change this
address.
– To leave this address unchanged, press [CANCEL]. A message displays that the address
is the same as before and displays the address.
– If you need to change the address, enter the new address using the keyboard. Enter the first
three digits and press [#]; enter the next three digits and press [#]; and so on. After you
have entered the address, press [ENTER]. A message displays that the address has been
changed and displays the new address.
4. From the CONFIG MEDIAPROXY screen press [
*
] to return to the Configuration function.
Changing the Baud Rate
The default baud rate is 9600. If you need to change the baud rate to 19200, use the following
procedure.
1. On the CONFIG screen, press the right scroll key until BAUD RATE is displayed.
IP ADDRESS
0
.0.0.0
Current Media
Proxy IP is:
192.168.31.1
CONFIG BAUD RATE
<-- ACCEPT -->
To Next Page
Loading...
