VERITAS Simone - Foot Pressure Regulator; Sewing with Extra Heavyweight Fabric or Multiple Layers of Fabric

66
SETTING DIFFERENTIAL FEED
Set by simply turning the Di󰀨erential feed control lever in the direction desired referring to
the chart below.
The adjustment can be made between 0.7 (negative e󰀨ect) and 2 (Positive e󰀨ect). These
settings give the best ratio of feeding.
For normal sewing, the lever should be set at 1. The lever can be reset even while sewing.
FOOT PRESSURE REGULATOR
Presser foot pressure has been correctly set at the factory, so you do not need to adjust it
for most of ordinary sewing. If adjustment is necessary, turn the foot pressure regulator to
higher number to increase or to lower number to decrease pressure.
SEWING WITH EXTRA HEAVYWEIGHT FABRIC OR MULTIPLE LAYERS OF FABRIC
A wide range of fabric can be overlocked on this machine, but it is recommended to tighten
screw as illustrated, when sewing with extra heavyweight fabrics or mulitiple layers of fabric.
Open working table for adjustment.
Loosen the screw when sewing with light to normal weight fabric or turning overedge cutting
width dial, or otherwise fabric may not be well cut.
The machine is set for normal weight fabrics from the factory.
EFFECT AND APPLICATION TYPE OF FEEDING SETTING FEED RATIO REAR: FRONT
Waver-free seams, Gathering
Positive di󰀨erential
feed
1 - 2 |-----------|----------------|
No di󰀨erential feed Neutral feed 1 |--------------|-------------|
Pucker-free seams
Negative di󰀨erential
feed
0.7
- 1 |-----------------|----------|
Illustration
*
I
: Di󰀨erential feed control lever
*
II
: Increase
*
III
: Decrease
*
IV
: Tighten
*
V
: Loosen
*
VI
: Screw