RADIO MANAGEMENT
• Select the Keep my channel selection during power cycleKeep my channel selection during power cycle
check box to save your channel selection when your
Verizon Wi-Fi Extender is rebooted.
• Enable DFS channels during channel scanEnable DFS channels during channel scan: DFS channels
are enabled by default during channel scans.
3. Click ScanScan to perform a channel availability scan for the
Verizon Wi-Fi Extender to identify the radio channels
providing the best Wi-Fi performance.
4. On the Channel SettingsChannel Settings page for either 2.4 GHz, 5 GHz
or 6 GHz, the following information displays and can be
configured:
• Channel AnalysisChannel Analysis - scans and displays channel
bandwidth and signal strength of available APs. Channel Channel
ScoreScore displays a network congestion score of one to ten
in each Wi-Fi channel. It can be used to determine which
channels to use or to avoid. Higher score indicates less
congestion in a channel.
• ChannelChannel Settings Settings - this is the radio channel used by the
Wi-Fi router and its clients to communicate with each
other. The channel must be the same on the router
and all of its Wi-Fi clients. Select the channel you want
the Wi-Fi radio to use to communicate, or accept the
default (Auto)Auto) channel selection. Then the router will
automatically assign itself a radio channel.
• WidthWidth - displays the bandwidth available to the Wi-Fi
channel currently in use on each band. Users can select
from available channels.
To Next Page
Loading...
