RADIO MANAGEMENT
3. After pressing the WPS button on your Verizon Wi-Fi
Extender, you have two minutes to press the WPS button on
the client device before the WPS session times out.
When the WPS button on your Verizon Wi-Fi Extender
is pressed, the Status LED on the front of your
Verizon Wi-Fi Extender begins flashing blue. The flashing
continues until WPS pairing to the client device completes
successfully. At this time, the Status LED turns solid blue.
If WPS fails to establish a connection to a Wi-Fi client
device within two minutes, the Status LED on your
Verizon Wi-Fi Extender flashes red for two minutes to
indicate the WPS pairing process was unsuccessful. After
flashing red, the light returns to solid white to indicate that
Wi-Fi is on.
Note: Wi-Fi Protected Setup (WPS) cannot be used if WPA3
security is enabled or SSID broadcast is disabled or if MAC
address authentication is enabled with an empty white list.
./ RADIO MANAGEMENT
You can view the channel settings for either 2.4 GHz, 5 GHz or
6 GHz of your Wi-Fi network.
To Next Page
Loading...
