Verizon Fios E3200 - Page 53

53
 / TROUBLESHOOTING
verizon.com/fios | ©2019 Verizon. All Rights Reserved
5.0d/ RESTORING YOUR FIOS HOME WIFI EXTENDER’S
DEFAULT SETTINGS
There are two ways to restore your Fios Home Wi-Fi Extender’s
default settings. It is important to note that after performing
either procedure, all previously saved settings on your
Fios Home Wi-Fi Extender will be lost.
• Using the tip of a ballpoint pen or pencil, press and hold the
Reset button on the back of your Fios Home Wi-Fi Extender for
three seconds.
• Access the GUI and navigate to the Advanced Settings page.
Select Factory Default option. Click the Restore Default Settings
button. For additional details, refer to the section 4.3/ Factory
Default section of this guide.
Note: If you reset or reboot your Fios Home Wi-Fi Extender, you
may also need to disconnect your Fios Home Wi-Fi Extender’s
power supply for a few minutes (3 or more) and then reconnect the
power cable. However, in order to provide full synchronization to the
coxial network, disconnecting and reconnecting the power may be
required.