– IGMP
– Daylight savings time support
1.3/ GETTING TO KNOW YOUR GATEWAY
1.3a/ FRONT PANEL
The front panel has two lighted indicators and a
WPS (Wi-Fi Protected Setup) button.
The Power/Internet light will be on and solid
when your Gateway is turned on, connected to
the Internet, and functioning normally.
The Wireless light will be on when your Gateway
Wi-Fi is turned on.
For additional information on the front lights
and error indications, refer the Troubleshooting
section in this Guide.
The WPS button is used to initiate Wi-Fi Protected Setup. This is an
easy way to add WPS capable devices to your wireless network.
When WPS is initiated from your Gateway, the wireless light slowly
flashes white for up to two minutes, allowing time to complete the WPS
pairing process on your wireless device (also known as a wireless client).
When a device begins connecting to your Gateway using WPS, the
wireless light rapidly flashes white for a few seconds, then turns solid
white as the connection completes.
10
01 / INTRODUCTION
verizon.com/fios | ©2014 Verizon. All Rights Reserved.
To Next Page
Loading...
Need help?
General
