www.versitron.com -30- SG71090
Configuration Description
DHCP Client Enable the DHCP client by checking this box.
IP Address Provide the IP address of this switch unit.
IP Mask Provide the IP mask of this switch unit.
IP Router Provide the IP address of the default router for this switch unit.
VLAN ID Provide the managed VLAN ID. The allowed range is 1 through 4095.
SNTP Server Provide the IP address of the SNTP Server.
Save Click to save the changes.
Reset Click to undo any changes made locally and revert to previously saved values.
Renew Click to renew DHCP. This button is only available if DHCP is enabled.
Note:
1. If DHCP fails and the configured IP address is zero, DHCP will retry. If DHCP fails and the configured IP
address is non-zero, DHCP will stop and the configured IP settings will be used. The DHCP client will
announce the configured System Name as hostname to provide DNS lookup.
2. The IP addresses should be in dotted decimal notation.
3.3 Configuring IP Address & Password via console and telnet
[Password] setting command is in System command group.
>System password <password>
↵
Parameters:
<password>: The allowed password string length is 0 to 31, and the allowed content is the ASCII
characters from 32 to 126.
[IP] command group is used to configure the switch’s IP settings. The command syntax is:
>IP DHCP [enable|disable]
>IP Setup [<ip_addr>] [<ip_mask>] [<ip_router>] [<vid>]
Parameters:
<ip_addr>: IP address (a.b.c.d), default: Show IP address
<ip_mask>: IP subnet mask (a.b.c.d), default: Show IP mask
<ip_router>: IP router (a.b.c.d), default: Show IP router
<vid>: VLAN ID (1-4095), default: Show VLAN ID
To Next Page
Loading...