Vertex SR Series - Page 12

- 12 -
CHAPTER 2: Basics
Installing Your Illumina SR
TobeginpoweringupyourVertexIllumina,rstplugallthepowercablestotheirrespectiveMeanWell
AC Adapter / Driver Units. Then connect each of the power cables into a GFCI/Surge Protected electri-
cal outlet.
Once all of the Drivers are assembled and plugged to a power source, you can proceed to connecting
thecontrolcableoftheIlluminaxture.
Depending on which model you have, the process will differ slightly.
Before plugging thextureinto an wall outlet,
arrange the cord in an anti-drip loop as pictured
to the left.
This arrangement will prevent any dripping wa-
ter from entering the electrical socket.
Failure to accomodate for this simple measure
canleadtoarehazzard.Thisistrueofallelec-
trical appliances within the vicinity of the aquari-
um or any body of water.