Vertex VX-2100 series - Channel-Specific Fine Alignment Mode

VX-2100/-2200
(
VHF
)
Service Manual 15
9. Sequential Tone Deviation
This parameter is to align the “Sequential Tone Deviation” (for 2-Tone, 5-Tone and DTMF sequential tones).
8. Sub Audio Deviation <CTCSS> / <DCS>
This parameter is to align the Deviation of Sub-Audio (CTCSS/DCS). The “TX VCO Tune Voltage” and “Max Deviation”
must be done before this alignment is started.
1. Press the “Start” button to start the alignment.
2. Set the value to get desired deviation (Wide: 0.6kHz)
on the deviation meter by changing the slide bar on
your PC.
3. Press the “OK” button after getting the desired value
to save the re-aligned value, the alignment of the MAX
DEVIATION is accomplished.
Alignment
1. Press the “Start” button to start the alignment.
2. Set the value to get desired deviation by changing the
slide bar on your PC.
3. Press the “OK” button after getting the desired value
to save the re-aligned value, the alignment of the SE-
QUENTIAL TONE DEVIATION is accomplished.
CH (Channel-by-Channel) Fine Alignment Mode
The CH Fine Alignment Mode allows you to align the
radio separately for every operating channel. The value
of each parameter can be changed to the desired position
using the “

” / “

” and up/down arrow keys, direct
number input, and by dragging the PC mouse.
To enter the CH Fine Alignment Mode, select “CH Fine
Alignment” in the main “Radio” menu. It will start to
“Upload” the written personalized data from the radio.
Pressing the “OK” button will then start the CH Fine
Alignment Mode.
Note: Detailed information for each step may be found in
the “Help” file within CE82 (Clone Editor).