VX-2100/-2200
(
VHF
)
Service Manual 16
Installation of Option
The FVP-25 is an Encryption/DTMF Pageing Unit which
permits secure voice communications with station within
your network, while preventing others from listening us-
ing normal communications equipment. It allows paging,
and enables selective calling using DTMF tone sequences.
The FVP-35 is an Rolling Code Encryption Unit which
permits secure voice communications with station with-
in your network, while preventing others from listening
using normal communications equipment.
The FVP-36 is an Voice Inversion Type Encryption Unit
which permits secure voice communications with station
within your network, while preventing others from lis-
tening using normal communications equipment.
Each optional Unit is easily programmed the configula-
tions using a Vertex CE82 programmer with an IBM PC-
compatible computer.
1. Disconnect the DC power cable.
2. Referring to Figure 1, remove the 8 screws affixing the
Top Cover, then remove the top cover.
3. Referring to Figure 2 & Figure 3, locate the empty con-
nector for the Optional Unit, connect the Optional Unit
here.
4. Replace the Top Cover and 8 screws . Installation is
now complete.
The VX-2100/-2200 transceiver can not install all Op-
tional Unit at the same time. The VX-2100/-2200 trans-
ceiver can install one of FVP-25, FVP-35, and FVP-36.
Figure 1
Figure 2
Figure 3
FVP-25/FVP-35/FVP-36
To Next Page
Loading...
