VERTIDRIVE B.V. | GIETERIJWEG 15 | 3089 JZ ROTTERDAM | THE NETHERLANDS - 13 -
T +31 (10) 763 02 00 | E SALES@VERTIDRIVE.COM | W WWW.VERTIDRIVE.COM
CHAMBER OF COMMERCE 24448205 | VAT NL 8201.77.064.B01
In all cases where we act as provider or supplier, our offers, orders placed with us, and agreements concluded with us are subject to the conditions and requirements laid down by the Netherlands Metal Association (the ‘Metaalunievoorwaarden’).
These conditions and requirements are filed with the registrar of the District Court of Rotterdam.
Locations of the magnetism
General safety instructions
The V700 Series robot complies with the fundamental safety and health requirements laid down in the relevant
European Union guidelines. However, careless, or inexpert use may lead to dangerous situations.
Always follow the safety rules as defined by local law and / or the company you are working for. Local safety rules
must always be followed in the first place. Please inform your supervisor in case there are contradictions to the safety
warnings and instructions given in this user manual.
When an application is installed on the robot, the operator must be VertiDrive (or partner(s)) trained and certified to
use this additional equipment (e.g., applicable when working with high pressure water jetting equipment). All safety
precautions and instructions relevant for the application (HP, UHP or abrasive blasting) must be adhered to insofar
applicable for the robot application.
Always observe the following general safety instructions:
5.3.1. Job functions, tasks, certification, and team line-up (UHP and abrasive equipment)
Operator
Trained, educated, and certified according to local requirements for Robot and application(s) concerned;
VertiDrive certified (or partner(s)) – Valid;
Operates the robot from outside the jetting area;
Operates the emergency shut-off on the robot.
Pump engineer
Trained, educated, and certified according to local requirements;
Monitors the proper operation of the pumping unit and supply of high-pressure water;
Operates the emergency shut-off on the high-pressure system;
Monitors the jetting area and is in visual and/or audio contact with the operator.
5.3.2. Before starting
Always perform an LMRA in the following three steps:
Recognizing potential dangers that could be present despite all the measures taken.
Employees should first ask themselves if they are risking exposure to these dangers. They must not start the
work if they believe the risks are unacceptable;
Thinking up solutions or measures to remove the perceived risks or make them acceptable;
Taking measures to let them carry out the work activities safely. The employee carries out the required
control measures to eliminate or control the dangers. If necessary, they should ask for help in achieving this;
To Next Page
